Results 1 to 2 of 2

Thread: Memphis Tricks!

  1. #1
    Join Date
    Feb 2007
    Location
    North Hollywood, CA
    Posts
    610
    Rep Power
    10

    Default Memphis Tricks!

    A Memphis owner asked if he could use the Memphis Thirty power section as a separate power amp for use with an external preamp.

    The loop return directly feeds the power amp stage (bypassing the reverb of course). To use the power amp stage only, simply activate the loop and set it to Series mode. Then use the Level switch for sensitivity range and the Level knob for volume adjustment. Note that the Loop HI/LO Level switch in this case will seem to do the opposite as it is labeled. This means that on the HI setting, you have to have a hot signal level coming out of your preamp. LO means you have to have a low level signal coming out of your preamp.

    There are also a couple of tricks to set the power amp operation. The power amp stage voicing changes when switching channels. It is looser and more open in the Clean mode and tighter in the Drive mode. To select your preferred response pattern, simply switch the channel selector from Clean to Lead. On whichever channel you have selected, that channels Power Shift switch will also set the power amp stage to 18 or 30W mode.

    These are very cool power amp features that will give you a lot of textural variety in your preamp settings.
    Last edited by support; 08-01-2011 at 07:04 PM.
    Dave Phelge
    Chief Misconception Eradicator
    support@fryette.com

    "We are what we pretend to be, so we must be careful what we pretend to be". - Kurt Vonnegut

  2. #2
    Join Date
    Feb 2008
    Location
    San Jose, California, United States
    Posts
    1,217
    Rep Power
    10

    Default

    damn it, i really want one of these...
    Ultralead
    D120H
    Sig X
    Fat Bottom 4x12
    D412
    Valvulator I

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •